Most cars on South African roads, and many driving test vehicles, have manual gearboxes. Learning to use the clutch feels impossible for the first hour and automatic after a few weeks. This guide takes you through it step by step, using the same habits the K53 examiner looks for. Practise in a quiet, open place with your supervisor first.

The three pedals

PedalPositionWhich foot
ClutchLeftLeft foot
Foot brakeMiddleRight foot
AcceleratorRightRight foot

Your left foot only ever works the clutch. Your right foot moves between the brake and the accelerator. The clutch connects and disconnects the engine from the wheels: pedal down means disconnected, pedal up means connected. On the official controls diagram the clutch is number 8, the foot brake 9 and the accelerator 10. See the controls diagram questions.

Step 1: before you start

  1. Adjust your seat so you can press the clutch all the way down with your knee slightly bent.
  2. Adjust your mirrors and fasten your seat belt.
  3. Check the parking brake is on.
  4. Press the clutch down and move the gear lever to neutral (it wobbles freely from side to side).
  5. Start the engine with the clutch still down.

Step 2: find the biting point

The biting point is where the clutch starts to connect the engine to the wheels. To find it:

  1. Clutch down, select first gear.
  2. Press the accelerator gently so the engine runs a little faster than idle.
  3. Lift the clutch very slowly. When the engine note drops slightly and the front of the car dips or strains, you are at the biting point.
  4. Hold your foot still there. Push the clutch down again and repeat until you can find it every time.

Step 3: pulling away

  1. Clutch down, first gear, a little accelerator.
  2. Raise the clutch to the biting point and hold it.
  3. Check your mirrors, signal if needed, and check your right blind spot.
  4. Release the parking brake.
  5. Slowly raise the clutch while gently pressing the accelerator. The car moves off.
  6. Once moving, lift your foot completely off the clutch.

If the car jerks and stalls, you lifted the clutch too quickly or did not give enough accelerator. Don’t panic: brake, clutch down, neutral, parking brake on, restart.

Step 4: changing up

As your speed increases, the engine gets louder and you change up a gear. Each change follows the same pattern:

  1. Ease off the accelerator and press the clutch down fully at the same time.
  2. Move the gear lever smoothly to the next gear, without looking down.
  3. Raise the clutch smoothly while gently pressing the accelerator.

As a rough guide for a small car: first gear to about 15 km/h, second to about 30 km/h, third to about 50 km/h, fourth to about 70 km/h, and fifth above that. Listen to the engine rather than staring at the rev counter.

Step 5: changing down and slowing

Use the foot brake to slow down, then select the gear that suits your new speed. Change down before a bend or junction, not in the middle of it, so both hands can be on the wheel while you turn.

Step 6: stopping without stalling

  1. Check your mirror, then brake gently with your right foot.
  2. Just before the car stops, press the clutch down fully so the engine does not stall.
  3. Once stopped, select neutral, apply the parking brake if you will wait, and take your foot off the clutch.

Step 7: hill starts

On an uphill slope the car will roll back if you are too slow. Use the parking brake to hold it:

  1. Parking brake on, clutch down, first gear.
  2. A little more accelerator than on flat ground.
  3. Raise the clutch to the biting point until the car strains against the parking brake.
  4. Check mirrors and blind spot, release the parking brake, and smoothly lift the clutch while adding accelerator.

The incline start is one of the K53 yard test manoeuvres. See how the incline start is scored.

Clutch habits the examiner penalises

Read the full K53 clutch notes and gear changing notes.

Manual or automatic for the driving test?

If you take your test in an automatic, your licence will be restricted to automatic vehicles. Testing in a manual lets you drive both. See licence and restriction codes.

Exam-style questions

  1. Which pedal is the clutch?

    1. The left pedal
    2. The middle pedal
    3. The right pedal
    Show the answer

    Answer: A

    In a manual car the clutch is the left pedal, worked with the left foot.

  2. When you stop, when should you press the clutch down?

    1. Before you start braking
    2. Just before the vehicle comes to a stop
    3. After the engine stalls
    Show the answer

    Answer: B

    Brake first, then disengage the clutch just before stopping, to avoid coasting and stalling.

  3. ‘Riding the clutch’ means…

    1. Resting your foot on the clutch pedal while driving
    2. Changing gear without the clutch
    3. Pressing the clutch fully down to change gear
    Show the answer

    Answer: A

    Resting your foot on the clutch wears it out and is penalised on the driving test.

Frequently asked questions

How long does it take to learn a manual?

Most learners can pull away and change gear smoothly after a few hours of practice. Smooth hill starts and stop-start traffic take a few weeks.

Is stalling on the driving test an automatic fail?

A single stall is not automatically a fail, but it costs points, and stalling in a dangerous place can be. Stay calm, secure the vehicle and restart.

Last checked: 19 November 2026.

Share:FacebookX
Free K53 course

54 guides, 1,735 practice questions, one goal: pass first time